Thank you for letting us know! You are correct you should be cupping.

Oh no! That video is actually a mistake. This project does not have a video. (Yet). 😉

It seems that some of our older SVG files are no longer compatible with the Cricut software update. I just updated this file, so you should be able to use it now. It will have a number 1 before the .svg so you can track that it is the update.

Thanks for letting me know!

I am downloading different svg files, and this is the only one that has a load error. I can upload it to the design space, but when I go to click “Add to Canvas,” it says, “Image Load Failure. There was a failure on the image(s) load.”

When I tried opening it, it showed the entire file, but when I went to open an editor, it showed that some of the leaf was cut off on the right hand side. This same cutoff is shown when I click “get info” on the file. I am not sure if this means there might be some issue with the file, or if this is something I am doing wrong on my end that the image won’t load into the canvas despite it being uploaded properly. Any other SVG I download from here works fine and makes it to the canvas, with the exception of this one.

Any ideas what to do? Cricut support has not been able to help.

Hi Donna! Yes the full photo tutorial is in the Downloads at the bottom of the post.

Hi Debra! We suggest using either glue or tape and place one petal on the stem at a time, use hot glue for quicker dry time. Try pulling down the petals as you’re gluing them into place so you have a better idea of where they will lay when the flower is complete. By waiting until the end to pull all the petals down you are a bit blind to how the flower will look in the end! We hope this helps!